If you’re the proud owner of a Jeep, then you know that keeping up with proper maintenance is essential to keeping your vehicle running well for years to come.
One of the most critical maintenance tasks is changing the oil in your jeep, which might seem daunting if you’ve never done it before.
In this Jeep maintenance 101 tutorial, we’ll show you how to change the oil in your Jeep properly to avoid any problems down the road. So, whether you’re a seasoned Jeep owner or just starting, read on for all the info you need to know!
Drain Engine Oil
The first step in changing your Jeep’s oil is to drain the old oil from the engine. You’ll need to locate the drain plug for the Jeep’s oil – you can usually find it near the bottom of the engine – and use a wrench to remove it.
Once the plug is removed, the oil will start draining out. Be sure to place a pan underneath the engine to catch the oil. Once all the old oil has drained out, you can proceed to the next step in changing the oil in your jeep.
Also Read: How You Can Customize a Carport To Fit Your Home?
Replace Oil Filter
Next, it’s time to replace the oil filter. The oil filter helps to remove impurities from the oil, and it should be replaced every time you change your oil. Not sure how to do it? Here’s a quick step-by-step guide.
- Locate the oil filter and unscrew it. Be careful not to touch the filter itself – it will be covered in dirty oil.
- Take the new filter and cover the O-ring with fresh oil. This will help to create a seal and prevent leaks.
- Screw on the new filter and tighten it until it’s snug.
3 – Fill Engine With Oil
After you’ve replaced the oil filter, it’s time to fill the engine with oil. You’ll want to use high-quality oil in your jeep and fill it to the “Full” line on the dipstick. Running your Jeep on low or empty oil can cause severe engine damage, so it’s essential to make sure you take this step seriously!
4 – Start Engine And Check For Leaks
Next, start the engine and check for leaks. You may have a mess on your hands and an oil-less Jeep if you don’t. Checking for leaks is a quick and easy way to ensure that your Jeep is lubricated correctly and that everything works as it should.
Also Read: Getting A Top-Rated Albuquerque AC Repair Company
5 – Reset Oil Service Indicator
Your Jeep’s oil service indicator tells you when to take your vehicle in for an oil change. Resetting the indicator is the final step in changing your oil correctly. To reset it, turn your ignition to ON (but don’t start the engine), press and hold the odometer reset button, and then turn the ignition off.
Changing The Oil In Your Jeep: In Closing
So, that’s it! Changing the oil in your Jeep is not as hard as it may seem. Just make sure to follow these simple steps, and you will be on your way to a properly running engine.
